Error Messages - Power One AURORA PVI-10.0-I-OUTD-400 Installations- Und Bedienungshandbuch

Use and installation manual
(PVI-10.0/12.0-I-OUTD(-S)-400 Rev:1.3)
If the system is ungrounded (neither of the two poles is connected to the ground),
then the first screen will be as follows
After the first check, the following screens alternate between one another
Vgrid 223.8 V
OK
The grid voltage and frequency values are shown, as well as if these values are
within range or not, until connection happens.
The connection will be signaled by a 'beep' from the buzzer and from this point
onwards, the screens will show measurements, following the modes described in
paragraph 5.5.3.
5.5.2

Error messages

After the connection has been established, if the inverter detects incorrect
information in the test cycle, the system will interrupt this cycle, indicating the
error code. Refer to the table in paragraph 5.4 for information on error codes.
To customize the display message, use the programming procedure described in
chapter 5.5.6.13 "Alarm Message".
Until the error has been solved, the system will continue to show the following
cycle of screens:
Once the error has been rectified, the inverter resets all of the function in progress,
restarting the connection (chapter.5.5.1 Connection of the system to the grid)
Next grid check:
30
Fgrid
OK
ERROR
Code ........
Type OUTD
Part No.........
In range
S/N ...................
Firmware......
In range
secs
50.17 Hz
Custom msg.........
55 97
Page of
Connection
.............