First Phase - Electric Parameter Check - Power One AURORA PVI-10.0-I-OUTD-400 Installations- Und Bedienungshandbuch

Use and installation manual
(PVI-10.0/12.0-I-OUTD(-S)-400 Rev:1.3)
5.5.3

First phase - Electric parameter check

GENERAL QUESTIONS RELATING TO THE USE OF DISPLAY KEYS:
During regular operation, the display will cycle through available data. The screens
change every 5 seconds, or can be alternated manually by pressing the UP (2
from display) and DOWN (3
In any case, to return to the previous menu, press the ESC key (1
display).
Activation of cyclical scrolling is indicated by the 2 arrows in the top left-hand
corner of the display (Fig
Scrolling can be blocked by pressing the ENTER key (4
padlock symbol will appear (Fig
If the measures performed previously (chapter .5.5.1) are found to give a positive
result, then the system will continue with other checks. The following screens
repeat cyclically as described in the paragraph "GENERAL QUESTIONS
REGARDING THE USE OF DISPLAY KEYS".
Type and p/n of the inverter
Serial number of the inverter and the firmware revision level.
E-da : Daily quantity of energy produced.
$-da: Daily energy savings. The value is expressed in the set currency.
rd
key from display) keys.
Fig. 21
.
21).
.
21).
Type OUTD
PN------------
S/N--------- xxxxxx
FW rel. C.0.1.1
E-da 0 Wh
$-da 0.0 EUR
E-tot -------------
E-par 0 KWh EUR
56 97
Page of
st
key from
th
key from display). A
nd
key