Wall Mounting - Power One AURORA PVI-10.0-I-OUTD-400 Installations- Und Bedienungshandbuch

Use and installation manual
(PVI-10.0/12.0-I-OUTD(-S)-400 Rev:1.3)
3.3.1

Wall mounting

AURORA must be mounted vertically, as shown in Fig
Included in the shipping package is a kit containing 5 steel screws 6.3x70 (with 4
M6 washers) and 4 SX10 anchors, necessary for attaching the metal bracket to a
concrete wall. Screws and anchors can be inserted into the 3 holes on the metal
bracket (Part. B) and then into the hole on the bottom of the inverter.
WARNING: the bracket must be attached to the wall horizontally, the
side with the hooks facing upwards, and the side with the holes facing
downwards.
NOTE: If the device is to be mounted onto a concrete wall, the anchors
provided should be used, and the holes must have a diameter of 10mm
and a depth of 75mm.
NOTE: When the device is installed on walls of different materials,
suitable mounting materials should be used. Power-One recommends
always using stainless steel screws.
Attach AURORA to the springs (Part. D) present in the upper part of the bracket,
by using the metal support fixed on the upper part of the rear of the inverter. This
metal fin has points in correspondence to the fixing point on the bracket hooks
(Part. A).
Once the upper part of the inverter has been attached, the lower part must be fixed
into place by inserting the screw in the appropriate hole.
23
Page
.
6.
97
of