Messages And Error Codes - Power One AURORA PVI-10.0-I-OUTD-400 Installations- Und Bedienungshandbuch

Use and installation manual
(PVI-10.0/12.0-I-OUTD(-S)-400 Rev:1.3)
5.4

Messages and error codes

The system status will be identified by message or error signals, shown on the
LCD display.
The tables below summarized the two types of signals which may be displayed.
The MESSAGES indicate AURORA current status, they do not caused by faults,
and do not involve any action; the messages will disappear once normal conditions
are re-established. See the W lines in the following table.
ALARMS indicate a possible fault in the equipment or connected parts. The signal
will disappear once causes are removed, except in the case of ground isolation
problems, for which qualified personnel will have to be called in order to have the
system restored to normal operation. The appearance of an error signal generally
involves some form of action, which will be managed by AURORA as far as
possible; when this is not possible, AURORA will supply as much helpful
information as possible to those performing the necessary maintenance on the
equipment or system. See the E line in the following tables.
Message Error warning
Sun Low
Input OC
Input UV
Input OV
Int.Error
Bulk OV
Int.Error
Out OC
Int. Error
Bulk UV
Int Error
Grid Fail
Int.Error
Int.Error
Error
type
W001 //
// E001
W002 //
// E002
// E003
// E004
// E005
// E006
// E007
W011 //
// E009
W003 //
// E010
// E011
Description
Input Voltage under threshold
Input voltage under threshold (in OFF
status)
Input Overcurrent
Input Undervoltage
Input Overvoltage
No parameters
No parameters
Bulk Overvoltage
Internal Communication Error
Communication error on internal bus
Output Overcurrent
IGBT Sat
Bulk Undervoltage
Internal Error
Internal error
Grid Fail
Grid out of range
Bulk Low
Ramp Fail
52 97
Page of