Inspecting The Package Contents; Selecting The Location For Installation - Power One AURORA PVI-10.0-I-OUTD-400 Installations- Und Bedienungshandbuch

Use and installation manual
(PVI-10.0/12.0-I-OUTD(-S)-400 Rev:1.3)
3.2

Inspecting the package contents

AURORA Inverter
Bag containing:
5 screws 6.3x70, 5 anchors SX10, 5
washers M6, 1 cable gland M20, 1 cable
gland M40, 1 gasket type 36A3M20, 1
cylinder TGM58, 1 key Torx20, 1 nut
1143M40N, 4 counterparts
MULTICONTACT Male, 4 counterparts
MULTICONTACT Female.
2 counterparts for signal connector (3
poles), 2 counterparts for signal connector
(8 poles)
Copies of this manual
Certificate of warranty
CD-ROM with communication software
3.3

Selecting the location for installation

AURORA must be installed in a location chosen according to the following
considerations:
AURORA must be placed at a height from ground level, so that the display and
status LEDs can be read easily.
Choose a location which is protected from direct sunlight, and is well-
ventilated. Avoid locations where air is unable to circulate freely around the
unit.
Leave enough room around the unit to allow for easy installation and removal
from the mounting surface.
Hardware and software maintenance is carried out through the door on the front
of the inverter. It is thus necessary to have easy access to this side, if you do not
wish to remove the unit from its mounting surface.
The figure below indicates minimum clearances around the inverter:
Description
20
Page of
Quantity (No.)
1
1
1
1
1
97