Maintenance - MICRO-EPSILON capaNCDT 6100 Betriebsanleitung

Maintenance

6.
Make sure that the sensor surface is always clean.
Disconnect the power supply before touching the sensor surface.
> Static discharge
> Danger of injury
Changing the target or very long operating times can lead to slight reductions in the operating quality (long-
term errors). These can be eliminated by recalibration, see Chap. 5.3.
In the event of a defect on the controller, the sensor
or the sensor cable please send us the effected
parts for repair or exchange. In the case of faults
the cause of which is not clearly identifiable, send
the whole measuring system back to
capaNCDT 6100
Maintenance
Switch off the power supply before cleaning.
Clean with a clamp cloth; then rub the sensor surface dry.
MICRO-EPSILON MESSTECHNIK
GmbH & Co. KG
Königbacher Str. 15
D-94496 Ortenburg / Germany
Telefon: +49/8542/168 - 0
Fax: +49/8542/168 - 90
info@micro-epsilon.de
www.micro-epsilon.com
Page 59