Operation And Maintenance; Service, Repair; Decommissioning, Disposal - Micro-Epsilon Dta-1G8 Betriebsanleitung

Operation and Maintenance

6.
A suitable controller is needed for operation the gauging sensors. Principally, the sensors must be calibrated
together with the electronic unit before initial operation (refer to the relevant operating manual for the con-
troller).
The sensor housing is sealed and must not be opened. If the sensor fails or malfunctions, it should be sent to
MICRO-EPSILON or the agent for repair or replacement. Attempts at repair by the user result in the loss of the
warranty.
7.
In the event of a defect on the sensor and sensor cable
concerned must be sent back for repair or replacement.
In the case of faults the cause of which is not clearly
identifiable, the whole measuring system must be sent
back to:
8.
induSENSOR, Series LVDT, Gauging Sensor
Operation and Maintenance
Do not grease or oil the gauging sensor.
Clean gauging sensor by blowing free with compressed air.

Service, Repair

Decommissioning, Disposal

Disconnect the power supply and output cable on the sensor.
The disposal is done according to the legal regulations (see directive 2002/96/EC).
MICRO-EPSILON MESSTECHNIK
GmbH & Co. KG
Königbacher Str. 15
94496 Ortenburg / Germany
Tel. +49 (0) 8542 / 168-0
Fax +49 (0) 8542 / 168-90
info@micro-epsilon.de
www.micro-epsilon.com
Page 33