Directives And Manufacturer's Declaration; Electromagnetic Environment - Ottobock Genium 3B1-3 Gebrauchsanweisung

Beep Vibration
signal signal
3x short 3x short
Battery charge level
During the charging process, the current battery charge level is indicated by the LEDs lit on the
side of the charger.
LEDs 0
Battery 0%-10%
charge level

16.3 Directives and manufacturer's declaration

16.3.1 Electromagnetic environment

This product is designed for operation in the following electromagnetic environments:
• Operation in a professional healthcare facility (e.g. hospital, etc.)
• Operation in areas of home healthcare (e.g. use at home, use outdoors)
The customer or user of the product must ensure that it is operated in such an environment.
Observe the safety notices in the section "Information on proximity to certain areas" (see
Page 60).
The following tables outline the test levels of the tests to be carried out. The higher value applies if
there is a difference between the operating environments listed in the tables below.
Event
Maintenance note:
e.g. service interval has been
exceeded, temporary disruption of a
sensor signal
1 2
11%-30% 31%-50%
Resolution
• Use the Cockpit app to check
the next maintenance date for
the prosthesis (see Page 79).
Should the date lie within the
next month, arrange a mainten­
ance appointment
O&P professional. For this
appointment, the O&P profes­
sional has to be provided with
the battery charger and power
supply in addition to the pros­
thesis with tube adapter.
• Conduct the self-test again by
connecting/disconnecting
battery charger.
• If the beep signal sounds again
and the maintenance date has
not yet
exceeded, visit the O&P pro­
fessional soon. If necessary,
the prosthetist will forward the
prosthesis to an authorised
Ottobock Service Center.
• The product can be used
without restrictions. However,
vibration signals may not be
generated.
3 4
51%-70% 71%-90%
with the
the
been reached or
5
>90%
95