Initial Commissioning; Measuring Location Prerequisites; Mounting Mirror Unit - Bosch ACC 200 Originalbetriebsanleitung

en 22 | ACC 200 | Initial commissioning
5.

Initial commissioning

5.1

Measuring location prerequisites

A B
Fig. 5: Test stand dimensions:
A = accessible area behind the reflector (minimum 80 cm)
B = Distance mirror- ACC (120 cm ±5 cm)
C = Vehicle location surface(500 cm)
Maximum irregularities
Installation equipment location surface:
Vehicle location surface:
Maximum tilt angle for the vehicle location surface
Maximum permissible tilt on
a) falling away location surface of vehicle: maximal 3°
Fig. 6: Falling away tilt angle of location surface for vehicle
b) rising location surface of vehicle: maximal 1°
Fig. 7: Rising tilt angle of the location surface
|
1 689 989 226 2019-07-24
C
1 mm
10 mm
5.2

Mounting mirror unit

Risk of crushing- danger from an unlatched
ACC 200 or falling mirror unit!
¶
With an improper attachment of °. ACC 200
or on a height adjustment of the mirror, a
risk of crushing either hands or feet exists
due to the weight of the mirror unit .
¶
Place ACC 200on a level surface.
¶
2 manual units for the height adjustment of
the mirror.
!
The mirror was separately packed on safety grounds.
i
We recommend using the included cover for the protec-
tion of the mirror during mounting.
!
Always hang and lock the mirror unit in the lowest
height position, ifACC 200 it is to be transported.
1. Fix the mirror in the framework of the mirror unit at
4 Nm.
2. Set mirror circa 10 cm to the side in the lower guide.
3. Press on the latch equipment (fig. 8, item 1).
4. Move and set the mirror unit (fig. 8, item. 2) in the
centre.
5. Release the latching equipment.
6. Fit the tension spring.
2.
1.
Fig. 8: Fitting the mirror
FIAT AG