Audit - FAS 300 T Handbuch

50
9.1.11
E
N
Exit
G
L
Enable traditional Audit
I
S
H
Audit protocol.
Connection port
Transmission speed
Peripheral address
Negotiated speed
Asset number
The control board is equipped with an RS232 socket. The I/O connector is a 9-pin male that uses the following
pins:
- Pin 2 VMC Tx
Audit protocol: By selecting
outside world via the infrared interface 082925 (IRDA interface) or through physical connection on the 9-pin
connector, according to the specifications of the EVA-DTS protocol, vers. 6.0.
If the command is set DEX UCS, the machine communicates with the outside world with the DEX-UCS
protocol.
Connection port: The machine offers the choice of the type of connection: Infrared interface (IRDA OUTPUT)
or cable interface on the 9-pin connector (RS232 OUTPUT).
Transmission speed : You are offered the choice of transmission speed, which must be consistent with the
setting of the 082925 board in the case of infrared connection (see related instructions). The selection is made
by scrolling through the various speed options from the drop-down menu
FAS International S.p.A. - Via Lago di Vico, 60 - 36015 SCHIO (VI) Italy - tel. +39 0445 502011 – fax +39 0445 502010 - e-mail:

AUDIT

Save
- Pin 3 VMC Rx
EVA-DTS DDCMP from the menu the
- Pin 5 Ground -Pin 7 CTS
FAS 300 T - ISSUE 01
machine communicates with the
info@fas.it