Loading The Cups - FAS 300 T Handbuch

22

LOADING THE CUPS

Use only vending machine cups with an outer edge diameter of 70 mm. or diameter 73mm. To adjust the cup
holder diameter on the dispenser move the lever "A" as shown in the figure.
To prevent the vending machine from malfunctioning, before loading the cups check that they are not damaged
or squashed into each other.
Turn off the vending machine by removing the key from the door safety switch, remove the cover from the cup
holder and start by inserting the cups in the column immediately to the left of the cup dispenser outlet, and
proceed in a counter clockwise direction.
Insert the key in the door safety switch and the cup holder rotation ratio-motor will rotate until the cups are
correctly positioned in the dispensing seat.
If using cups with a 73 mm diameter, remove the two reducers "C" inserted in the cup chute.
E
N
G
L
I
S
H
FAS International S.p.A. - Via Lago di Vico, 60 - 36015 SCHIO (VI) Italy - tel. +39 0445 502011 – fax +39 0445 502010 - e-mail:
FAS 300 T - ISSUE 01
info@fas.it