FAS 300 T Handbuch Seite 34

32
Enable pre-washes with nozzles out: enables milk/instant_1 coffee pre-washes with nozzles in the
dispensing position.
Enabling this option entails an increase in delivery time if there is a pre-wash.
Enable nozzles out at the end of pre-wash: if the previous option has not been enabled the possibility is
defined to enable a complete movement of the nozzles in order to drain residual water from the pipes. Enabling
this option entails an increase in delivery time if there is a pre-wash.
Enable the anti-scale function (mixer wash): in addition to timed washes (see
E
a further timed wash can be enabled to improve cleaning and to reduce the scaling formation on solenoid
N
valves.
G
This wash can be set for each single mixer: its duration is according to the timing set in the "setting mixer #"
L
timing bar, and is carried out when the pause time after the last use settable in the "setting mixer #" timing"
I
bars, has lapsed
S
H
Enable wash with nozzles out: by enabling this option, the automatic and sequential washes are carried out
with nozzles in the dispensing position
Configure Alarm 10 (coffee dispensing time-out) as non-blocking: defines the possibility of
enabling/disabling the blocking of all espresso selections in the event of Alarm 10. Even in the event of a non-
blocking selection, the error will be recorded in any case
Configure Alarm 17 (soluble dispensing time-out) as non-blocking: defines the possibility of
enabling/disabling the blocking of all espresso and soluble selections in the event of Alarm 17. Even in the
event of a non-blocking selection, the error will be recorded in any case .
Set instant grinding: By enabling this option, the coffee gets ground for the current dispensing; by disabling
it, the coffee gets ground for the subsequent dispensing.
Enable automatic grinding: allows the enabling of the "automatic grinding" (if fitted). By flagging the box, the
automatic grinder gets enabled and it can be electrically powered. To set the wanted granulometry, which the
grinder will then automatically keep, go to the services menu and click icon
Set cup column time-delay stop: this parameter adjusts the delay for stopping the cup column, which
ensures an accurate alignment between the tube and the cup outlet opening. The delay is counted from the
time the cup presence microswitch switches over. Default value, 12 tenths of a second. It can vary between 5
and 30
Set nozzles retract time-delay: adjust the retract delay of the nozzles at the end of dispensing. Default value
50 tenths of a second, but it can vary between 20 and 70.
Set boiler temperature: this parameter allows adjustment of the boiler operating temperature. The predefined
value is 95°C, but it may vary from 70°C to 120°C.
Boiler temperature delta: it represents the temperature differential, a value which is added to the boiler's
operating temperature to compensate the heat loss of the selected beverage caused by the dispersiveness of
the dispensing system after a period of inactivity. This value is predefined at +15°C.
N.B.: the sum of the above values cannot exceed 120 °C.
Enable slave: this command enables the master/slave connection. It is possible to connect one slave snack
machine. Once the box has been flagged in the main menu screen, the
allows access to the various settings of the slave machine connected.
FAS International S.p.A. - Via Lago di Vico, 60 - 36015 SCHIO (VI) Italy - tel. +39 0445 502011 – fax +39 0445 502010 - e-mail:
.
Slave icon will appear which
FAS 300 T - ISSUE 01
), within this option,
info@fas.it