FAS 300 T Handbuch Seite 36

34
Payment system: it is possible to choose the type and mode of coin mechanism operation. The parameter
can have the following values:
•
EXECUTIVE with prices managed in the machine
•
EXECUTIVE PRICE HOLDING (i.e. prices programmed in the coin mechanism); in this case, prices
programmed using the
mechanism. Alternatively you can set the "Price-Display" parameter. If enabled, the machine will
exclusively use the price information coming from the payment system.
•
BDV
•
MDB
E
N
Single/multi-sale: it is possible to choose whether the vending machine operates in single-sale mode and
G
gives change in cash mode. If this is not possible, the sum is added to the amount received through
L
overpricing. Conversely, if the vending machine operates in multi-sale mode, the amount in excess of cost
I
after the sale is displayed once again and can be recovered by simply pressing the "change" button or used
S
for a new selection.
H
Setting the signal for payment system out of order: it is possible to choose whether to block the vending
machine if the payment system is out of service
Enable change-giver engine: NOT PRESENT
Coin insertion microswitch; NOT PRESENT
Change-giver motor cycle interval: NOT PRESENT
FAS International S.p.A. - Via Lago di Vico, 60 - 36015 SCHIO (VI) Italy - tel. +39 0445 502011 – fax +39 0445 502010 - e-mail:
Prices icon must be the same as those programmed in the coin
FAS 300 T - ISSUE 01
info@fas.it