General Guidelines; Use Of The Automatic Vending Machine; Transport And Storage - FAS 300 T Handbuch

8
Before connecting the machine to the hydraulic and power system, it is recommended to:
•
Read these instructions carefully, as they provide you with important indications relating to installation
safety.
•
Keep this booklet in the inside pocket of the machine for any further consultation.
•
This machine has been conceived for indoor installation. It is therefore forbidden to install it
E
outdoor.
•
N
The manufacturer cannot be held responsible for possible damages deriving from improper, wrong and
G
unreasonable use.
•
L
After having removed the packaging make sure that the machine is in good condition. If in doubt, do not
I
use the machine, call directly the seller.
S
•
The packaging (plastic bags, expanded polystyrene, nails, etc.) should be kept away from children,
H
because it could become dangerous for them.

USE OF THE AUTOMATIC VENDING MACHINE

The automatic vending machine is intended to be used for dispensing beverages which are prepared by mixing
foodstuffs with water (Instant coffee, instant chocolate, sugar, coffee in beam form, instant tea, instant barley,
skimmed milk powder granules). Use only products which have been declared by the manufacturer as suitable
for automatic vending in refillable canisters. The selections dispensed by the automatic vending machine must
be consumed immediately and they must not be preserved or recycled for later use.
Adhere strictly to the manufacturer's indications regarding the expiry date for each individual product.

TRANSPORT AND STORAGE

In order not to cause damages to the distributor, the loading and unloading manoeuvring have to be performed
with particular care.
The loading/unloading manoeuvres must be carried out by lifting the machine with a lifting truck, either motor-
driven or manual, and by positioning the forks in the area under the pallet.
To move the machine over short distances, for example inside a premises or office, the pallet need not be
used. Proceed however with maximum caution to prevent damaging the machine. It is always prohibited:
• To lie the machine down;
• To drag the distributor with ropes or similar;
• To lift the distributor from the sides;
• To lift the distributor with any sling or rope;
• To shake the distributor and its packaging.
As to the storage of the machines, it is appropriate that the environment of conservation is very dry with
temperatures between +1° and +40° C.
Cover the machine after having positioned it in a protected environment and anchor it to prevent it from moving
and to avoid accidental knocks. It is important not to put one packed machine on the other and to maintain
the vertical position shown by the arrows on the packaging itself.
FAS International S.p.A. - Via Lago di Vico, 60 - 36015 SCHIO (VI) Italy - tel. +39 0445 502011 – fax +39 0445 502010 - e-mail:
2

GENERAL GUIDELINES

This section is for qualified assistance staff only.
FAS 300 T - ISSUE 01
info@fas.it