Water Inlet Solenoid Valve; Control Card; Boiler And Air-Break - FAS 300 T Handbuch

20

WATER INLET SOLENOID VALVE

The water inlet solenoid valve, located on the back of the
vending machine, is accessible from the rear of the
machine. It is fitted with a mechanical device which
automatically stops the water from entering in the event of a
problem with the solenoid valve or the water circuit.
To reset normal operation, proceed as follows:
•
Switch off the machine by means of the main switch and
E
pull out the power plug;
N
•
pull out and empty the overflow tube "A"; try not to spill
G
the contents inside the machine;
L
•
Close the water mains cock outside the vending
I
machine.
S
•
Loosen the union which fastens the water supply tube
H
to the solenoid valve in order to release the residual
pressure, then re-tighten.
•
Reinsert the tube "A" in its position, open the water
supply cock and reconnect the electrical power.

CONTROL CARD

The control card, located on the back of the
vending machine, houses the central control
unit, which oversees all machine operations and
control of the sensors.

BOILER AND AIR-BREAK

The pressure boiler has a capacity of 650cc.
and it is fitted internally with a 1450W heating
element.
The water level in the air-break is controlled by
a level sensor.
A vibration pump, which dispenses the amount
of water programmed for each selection
(controlled by the volumetric counter), is
installed between the boiler and the air-break.
FAS International S.p.A. - Via Lago di Vico, 60 - 36015 SCHIO (VI) Italy - tel. +39 0445 502011 – fax +39 0445 502010 - e-mail:
FAS 300 T - ISSUE 01
info@fas.it