Installation; Disinfecting And Sanitizing - FAS 300 T Handbuch

10
E
N
G
L
I
S
H
Description of connections:
1. Plug "Schuko"
2. Differential
switch
3. Water tap
4. Water pipe

DISINFECTING AND SANITIZING

During the installation stage you must proceed with the total sanitization of the complete hydraulic circuit and
of the parts in contact with the foodstuffs in order to eliminate every trace of bacteria which may have formed
during storage. Also use sanitizing products (e.g. chloro-detergents) for cleaning inside the vending machine,
complying scrupulously with the doses specified on the label. Do not use detergents which are too "aggressive"
as they could damage some of the parts. The manufacturer declines all responsibility for damage caused by
the improper use of such detergents or the use of toxic agents.
FAS International S.p.A. - Via Lago di Vico, 60 - 36015 SCHIO (VI) Italy - tel. +39 0445 502011 – fax +39 0445 502010 - e-mail:
3
Installation should be carried out by skilled staff in accordance with current regulations
and manufacturer's instructions. Installation should also comply with CEI EN 60335-1
"Safety of household and similar electrical appliances.
A faulty installation can cause damage to people, animals and things, for which the
manufacturer cannot be held responsible.
Electrical safety is guaranteed only if the machine is correctly connected to an effective
earthed system installed in compliance with current safety rules. It is necessary to verify
this essential safety condition. If in doubt ask skilled staff to control the whole system.
The manufacturer cannot be held responsible for damages caused by missing earthed
system.
The machine cannot be installed in places where the room temperature is not comprised
between 5° and 35°C, in places that are not protected by atmospheric agents and in
places where jets of water are used for cleaning.
The vending machine must be installed on a surface (floor, intermediate
floor) of suitable bearing capacity. Check that the power of the whole
electrical system is adequate for the maximum power of the machine
(see plate). The appliance must be connected to a power supply mains
featuring earthing which complies with current legislation. The
manufacturer recommends providing an electric power supply mains for
the vending machine which is equipped with a disconnecting device
having a contact opening of at least 3 mm. Ensure that the plug is
accessible after installation. It is strictly forbidden to use extension
cords, adaptors or multiple jacks.
When connecting the machine to the power supply, please take all
instruction of this booklet into account.
In order to avoid dangerous overheating it is advisable to unwind the
supply wire entirely.
Do not clog ventilation and dissipation grates.
All cleaning operations must be carried out after disconnecting power
and water supply as described for previous operations.
Once connections have been made, the vending machine must be
placed near to a wall so that its back has a minimum distance of 5 cm
from the wall in order to allow a regular ventilation (connectors are part
of the vending machine). Do not cover with clothes or similar.
The vending machine performs best at a room temperature between 10
and 32°C. Do not therefore install the machine near heat sources.
circuit breaker

INSTALLATION

FAS 300 T - ISSUE 01
info@fas.it