Warnings For The Demolition Of The Machine; Master / Slave Connection - FAS 300 T Handbuch

FAS 300 T - ISSUE 01
•
To empty out the coffee grinder-metering unit;
•
To clean the machine thoroughly and to dry it;
•
To check carefully for damaged or worn parts and to replace them;
•
To check that the screws and bolts are securely tightened;
•
To cover the machine after having stored it in a protected environment.
To re-set the machine at work, comply with the instructions given in the paragraph "Installation" of this manual
and pay particular attention if food products are to be sold (see paragraph "INSTALLATION").

WARNINGS FOR THE DEMOLITION OF THE MACHINE

If the machine is disassembled in order to be definitively demolished, it is obligatory
to follow the rules in force regarding the protection of the environment. All ferrous,
plastic or similar materials should be taken to the authorized depots.
Should you have any queries, you are recommended to contact competent local refuse disposal authorities.

MASTER / SLAVE CONNECTION

It is possible to connect a SLAVE vending machine (YOUNG 170 FULLVIEW) to the MASTER vending
machine . A serial cable present in the Slave machine is used and the connector is accessible from the back
of the machine.
Remove the back, connect one end of the serial cable to the connector J13 indicated by the arrow.
Reassemble the back, and pass the serial cable as shown in the figure.
FAS International S.p.A. - Via Lago di Vico, 60 - 36015 SCHIO (VI) Italy - tel. +39 0445 502011 – fax +39 0445 502010 - e-mail:
Connect the other end of the serial
cable to the slave machine YOUNG
170 Fullview.
info@fas.it
13
E
N
G
L
I
S
H