Unpacking Procedure - FAS 300 T Handbuch

FAS 300 T - ISSUE 01

UNPACKING PROCEDURE

Remember to remove packing materials or equipment inside the vending machine
which could affect the correct function of the machine.
The packing material must be removed carefully to avoid damaging the machine. Inspect inside and outside
the cabinet for any damage. Do not destroy the packing material until the manufacturer's representative has
examined it.
•
Screw up the feet into their housings on the bottom of the machine. Adjust the feet with a leveller to have
the machine perfectly horizontal.
•
Open the machine door and remove the inside transport reinforcements. These parts are marked by
specific signs inside the machine.
•
Before connecting the machine to the power supply make sure that data on the plate correspond
to those of the electric and the water supply networks.
•
Do not cover with clothes or similar.
THE MANUFACTURER DISCLAIMS ALL RESPONSIBILITY FOR ANY DAMAGES
CAUSED BY THE NON-COMPLIANCE WITH THE CAUTIONS DESCRIBED IN THIS
SECTION.
FAS International S.p.A. - Via Lago di Vico, 60 - 36015 SCHIO (VI) Italy - tel. +39 0445 502011 – fax +39 0445 502010 - e-mail:
9
E
N
G
L
I
S
H
info@fas.it