Electrical Connection - EKOM DUO 2V Anleitung Zur Installation, Bedienung Und Wartung

DUO
9.3. Compressed air outlet
(Fig.10)
Lead the pressure hose from compressor output via rear
hole of the housing (8) to the appliance (Fig. 9C) or connect
it to the output from a floor. Connect the pressure hose onto
the output of compressed air (9) of a compressor with a nut
(10) (cone) using a locked cone clutch.
9.4.

Electrical connection

Plug the electrical cord into the mains.
The appliance is equipped with a grounded plug. Make sure this connection complies with
local electrical codes. The mains voltage and frequency must comply with the data stated

on the appliance label.
Electrical cable may not contact the hot parts of a compressor. Insulation could be
damaged!
If any electrical cord or air hose is damaged it must be replaced immediately.
 Keep the socket easily accessible to ensure that in an emergency the appliance can be safely
disconnected from the mains.
 Connection to the power distribution box must be max.16A.
 Electricity for the compressor is via a socket located in the box.
The connection of the earth ground pin  6mm (1) (Fig.11) with other
appliances must be completed in accordance to local valid electrical
regulations. The female socket (2) which is not included in the standard set, is
an optional accessory.
9.5. Compressor connection
(Fig.4)
Connect mains cord to housing socket (34). Place the cord under clamp (38).
9.6. Chance in the door opening

Disassemble the door, rectification screw (3

Mount holder of the hinge D to the left side of the casing.

Rotate the door by 180º.

Insert a spacer (5) between the hinge H(1) and the bottom side of the door

Mount the door.

Disassemble the lock (6) on the door, rotate it by 180º.

Disassemble the latch (7) on the lock, rotate it by 180º.

Mount the lock to the door.
A
11/2015
and the holder (2) of the hinge D (4).
)
- 35 -
9
10
Fig.10
Fig.11
NP-DUO-4_11-2015-MD