EKOM DUO 2V Anleitung Zur Installation, Bedienung Und Wartung Seite 35

DUO
9.1. Underpressure connection
(Fig.7, Fig.8)
The suction aggregate is equipped with hoses for sucking and discharge.
input/output of suction aggregate are lead at the rear wall of the housing into its bottom part. The hoses of
sucking aggregate may be connected to piping in a floor or to lead out via the rear hole of the housing (9).
Connect the sucking hose to piping leading to an appliance and connect the discharge hose to piping lead
out beyond the working space of operators. If it is necessary to reduce the noise level of air passing through
the hose, it is possible to connect noise suppressor to exhauster output (see Chapter 6 Auxiliary Equipment).
If it is necessary to lead the output of air from exhauster into interior, it is necessary to connect noise
suppressor with bacteriological filter onto the exhauster.
Fig.7 - Installation DUO, DUO 2V (distributions in a floor)
Fig.8 - Installation DUO 2 (distributions in a floor)
11/2015 - 33 -
The hoses connected to
1 – Outline of the case
2 – Outline of the base
3 – Front part of the case - door
4 – Pressurised air connector G3/8"
5 – Suction pump control voltage
2Ax0.75
6 – Suction pump – in
7 – Suction pump - out
8 – Supply voltage
230V/50(60)Hz, 3Gx1.5
- all dimensions in milimeters
- wall distance min. 100mm
Connection via the hole
in the rear part of the
casing.
1 - Outline of the case
2 - Outline of the base
3 - Front part of the case - door
4 - Pressurised air connector
G3/8"
5 - Suction pump control voltage
2Ax0.75
6 - Suction pump 1 – in and out
7 - Suction pump 2 – in and out
(DUO 2)
8 - Supply voltage
230V/50(60)Hz
3Gx1.5
- all dimensions in milimeters
- wall distance min. 100mm
NP-DUO-4_11-2015-MD