Unloading The Cot From A Vehicle (Manual Method); Cot Operation (Continued) - Stryker Power Pro Cot 6500 RUGGED Betriebshandbuch

Unloading the Cot from a Vehicle - Manual Method
Unloading the cot from the vehicle while a patient is on the
cot requires a minimum of two (2) operators, positioned
at each end of the ambulance cot. Each operator must
grasp the ambulance cot frame securely.
Disengage the cot from the cot fastener (For more
detailed instructions, reference the ambulance cot
fastener installation/operation manual - Stryker part
number 6370-090-010).
Lift the vehicle bumper to the raised position (if
equipped).
Operator 1 - Grasp the ambulance cot frame at the
foot end. Pull the manual release lever to lower the
undercarriage to its fully extended position (Figure
50). Pull the cot out of the patient compartment until
the safety bar engages the safety hook. Operator two
should verify that the bar engages the safety hook.
WARNING
To avoid injury, verify the safety bar has engaged the
safety hook before removing the ambulance cot from the
patient compartment.
Operator 2 - Stabilize the cot during the unloading
operation by securely grasping the outer rail.
Operator 2 - Push the safety bar release lever forward to
disengage the safety bar from the safety hook in the
patient compartment (Figure 57).
WARNING
Do not pull or lift on the safety bar when unloading the
cot. Damage to the safety bar could result and injury to
the patient or operator could occur.
Remove the load wheels from the patient compartment of
the vehicle.
CAUTION
When unloading the cot from the patient compartment,
ensure the caster wheels are safely set on the ground or
damage to the product may occur.
www.stryker.com
Cot Operation
Figure 55 - 2 Operators Unloading the Cot
Figure 56 - 2 Operators - One Pushing the Extend
Figure 57 - Disengaging the Safety Bar
6500-009-005 REV A
Button
9