Stryker Power Pro Cot 6500 RUGGED Betriebshandbuch Seite 59

BASE LUBRICATION
• The POWER PRO XT has been designed to operate without the need for lubrications.
®
• Tri-Flow with Teflon lubricant may be used to reduce the force required to raise the undercarriage and to minimize
wear.
• Do not use silicone, WD-40™, or lithium grease. They could harm the moving parts of the cot.
Figure 65 - Base Lubrication Locations
1. Raise the POWER PRO XT cot to the upper position.
2. Remove one of the button head cap screws (item A) from both the patient right and patient left litter pivot inner lift
tubes (item # 6500-001-034 and 6500-001-035).
3. Using the plastic applicator tube, spray Tri-Flow with Teflon
recently removed button head cap screw locations.
4. Let stand for two minutes to allow the lubricant to coat the inside of the tube.
5. Extend the retractable head section until it locks in place (item # 6500-001-020).
6. Tip the cot toward the foot end until the operator lift bars rest on the floor.
7. Remove the two caster mount spacers (item B) from the outer base tube assembly (item # 6500-001-054).
8. Remove both the upper and lower X-frame guards (item C) from the outer lift tube assembly (item # 6500-001-021).
9. Move foot base tube (item D) by sliding horizontally to the patient left or right. Do not completely remove this tube or
the cot will collapse. Lubricate one side only in the next step and then the other.
10. Remove outer lift tube assemblies one at a time (item number 6500-001-021) from the outer base tube frame (item
number 6500-001-056).
11. Using the plastic applicator tube, spray Tri-Flow with Teflon
onto the upper bearing (item E). Repeat for other side.
12. Reverse above procedures to assemble the cot.
13. Wipe off any excess Tri-Flow from the external components of the POWER PRO XT cot.
www.stryker.com
Preventative Maintenance
A 0004-590-000
®
6500-009-005 REV A
lubricant (Stryker part # 6082-190-012) into each of the
®
lubricant (Stryker part number 6082-199-012) directly
0007-086-000
C 6500-001-180
B 6500-001-179
E
6500-001-186
D 6500-001-229
5