Adjusting The Cot Height; Using Additional Assistance - Stryker Power Pro Cot 6500 RUGGED Betriebshandbuch

Adjusting Cot Height
Changing the height of the cot while a patient is on the cot requires a minimum of two (2) operators, positioned at each
end of the ambulance cot.
Operator 1 - Grasp the ambulance cot frame at the foot-end. Actuate the control switch, depress either the (+) or (–)
button depending on desired travel direction, and allow the litter to raise/lower to the desired position.
Operator 2 - Maintain a firm grip on the outer rail until the ambulance cot is securely in position.
WARNING
Grasping the
moving parts. To avoid injury, use extreme caution when placing your hands and feet near the base tubes while raising
and lowering the ambulance cot.
NOTE
If the push button switch remains activated, the motor will remain halted until the operator releases the button. Once the
push button is released, actuate the extend (+) button again to "jog" the cot height up further.
CAUTION
Do not "jog" the ambulance cot past the established load height of the product when the safety bar engages the vehicle
safety hook or damage may occur to the product.

Using Additional Assistance

Changing Levels
Helper
Two
Operators
Two Helpers
Operator
Helper
Two
Operators
Four Helpers
Operator
www.stryker.com
Cot Operation
ambulance cot improperly can cause injury. Keep hands, fingers and feet away from
Rolling
Operator
Operator
Helper
Helper
Helper
Operator
Helper Operator
Helper
6500-009-005 REV A
Loading/Unloading
Helper
Helper
Operator
Helper
Operator
Helper Helper
Helper
Operator
Helper
Operator
Helper
Operator
Helper
Helper
Helper Operator
51