Resetting The Netfilter Rules - G&D VisionXS-IP-C-DP-UHR Installation Und Bedienung

Configuration
1. In the menu, click on
2. Click on
System defaults
3. Select the scope of the recovery:
Reset all settings
 Reset all settings of the device.
Reset only local network settings
 Reset only local network settings.
Reset only KVM application settings
 Reset all settings except the local network settings.
4. Click on
Set system defaults

Resetting the netfilter rules

In the default settings, all network computers can access the system's IP address
(open system access).
With the Config Panel web application, you can create netfilter rules to control the
access. After a netfilter rule has been created, the open system access is deactivated
and all incoming data packets are compared to the netfilter rules.
The created netfilter rules can also be deleted with this function.
How to delete the created netfilter rules:
1. Open the remote OSD of the computer module by pressing
(default: Ctrl
Open the local OSD of the user module by pressing the
Alt + Num ) if you want to reset the local settings of the user module.
2. Select the row
3. Select the row
4. Confirm the security prompt or cancel the process.
49 · G&D VisionXS-IP-C-DP-UHR
.
System
.
.
+ Num ) if you want to reset the settings of the extender system.
Network and press
Reset netfilter configuration
Enter .
and press
Enter
remote hotkey
local hotkey (default:
.