Husqvarna SM 610 2006 Werkstatt-Handbuch Seite 399

In the C.D.I. system the electrical energy generated by the alternator charges the condenser.
The energy is released in a single surge at the specified ignition timing and the current flows through the primary side of the ignition coil. A high voltage is
induced in the secondary windings of the ignition coil, resulting a strong spark between the ignition spark plug gap.
The digital electronic ignition allows to change the timing curve according with the following items:
- ENGINE r.p.m.;
- CARBURETOR THROTTLE VALVE POSITION SENSOR;
- ENGAGED GEAR.
This system allows to optimize the engine performances in every condition of employment. In case of throttle valve or transmission gear failure, the ignition
is able to allow the use of the motorcycle however.
The electronic ignition systemconsists of (page M.23):
- Electronic power unit (1);
- Alternator (2);
- Voltage regulator-rectifier (3);
- Spark plug (19);
- Neutral position sensor (22);
- Ignition coil (23);
- Carburetor throttle position sensor TPS (24);
- Engine stop switch (6).
ELECTRONIC IGNITION SYSTEM WIRING DIAGRAM
M.18
BOZZA
IMPIANTO ELETTRICO
ELECTRIC SYSTEM
INSTALLATION ELECTRIQUE
DRAFT
ELEKTRISCHE ANLAGE
INSTALACIÓN ELECTRICA
ELECTRONIC IGNITION SYSTEM
ELECTRONIC IGNITION SYSTEM DIAGRAM
Legenda colore cavi / Cable colour coding
Legende couleur câbles / Kabelfarben
Referencias colores de los cables
R Rosso/ Red/ Rouge/ Rot/ Rojo
O Arancio/ Orange/ Orange/ Orange/
Arancio
B Blu/ Blue/ Bleu/ Blau/ Azul
Bk Nero/ Black/ Noir/ Schwarz/ Negro
Y Giallo/ Yellow/ Jaune/ Gelb/ Amarillo
W Bianco/ White/ Blanc/ Weiss/ Blanco
G Verde/ Green/ Vert/ Grün/ Verd
Bn Marrone/ Brown/ Maron/ Braun/ Castano
P Rosa/ Pink / Rose/ Rosa/ Rosa
Gr Grigio/ Grey/ Gris/ Grau/ Griso
Part. N. 8000 A4640 (04-2005)