ECOLAB EMP KKS E60 Bedienungsanleitung Seite 174

Device installation
7.2.2.1 Installing suction pipe with low level advance warning and empty report
NOTICE!
Slot I must always be assigned, either through the mounted strapping plug
(protective cap with corresponding symbol,
Ä Chapter 7.2.1 ' Inputs and outputs' on page 36) or through connection to
the empty report device (suction lance plug).
The setup of low level contact is invertible.
Ä Chapter 10.3.8 'Configuration / Low-level contact' on page 76).
(
Fig. 11: Installing suction pipe with low level advance warning and empty report
Low-level advanced warning active (invertible circuit logic,
10.3.8 'Configuration / Low-level contact' on page 76), empty report symbol on display
flashes , pump is not locked.
1 + 4 = Input low-level warning low-level advanced warning open:
PIN Assignment
1 Relay input
4 GND (┴)
Empty report active (invertible circuit logic,
contact' on page 76), empty report symbol on display appears
3 + 4 = Input empty report Switch contact empty report open:
PIN Belegung
3 Relay input
4 GND (┴)
417101442 Rev. 12-02.2019
Ä Chapter
Ä Chapter 10.3.8 'Configuration / Low-level
38
, pump is locked.