SIP SILVERCUT DISC 340 F FC Betriebsanleitung Seite 168

3
Putting the mower into the transport position
– Move the side guard to the transport position (1A).
– Use the provided special tools (2) from the manual
pack (3) for opening the protection cover.
– Lift the mower using the tractor hydraulics.
Loading the mower from the transport to the
working position
– Using the tractor hydraulics, lower the mower to
the ground.
– Place the side guards of the cutter bars in the
protection position (1B).
– The mower is in the working position.
5. Mowing
2
5.1 Lifting the cutter bars when driving into new
row
When changing from a mowed row to a new one, you
can raise the cutter bar with the tractor arms.
39
– Perform the repair work, maintenance,
cleaning and stopping works only with
the switched off drive and stand still
engine! Remove the ignition key.
– Maximum number of P.T.O. shaft
rotations is 1000 rpm. Working with
maximum rpm is recommanded.
Suitable driving speed is to be selected.
Pay special attention when driving
downwards!
– All protections must be undamaged and
in protective position.
– There is a danger of hard substance
eject near the machine when mowing
(stone, cutting blade). Nobody is
allowed to stay near the working area
when mowing!
– It is forbidden to climb on the machine
or driving on it!
– Check the position of the hitch.
– Check the operation of the floating
position.
– Check the adjusted relief pressure.
– Set the slow start-up of the machine.
– Set the number of cardan shaft
rotations to 1,000 rpm.
– Stop mowing when sudden noise or
vibration appears. Continue after
eliminating the disturbance otherwise
require service intervention.
– There is a danger of hard parts flying
from the mower when mowing (stones,
blade). Nobody is allowed to stay in the
danger area of the machine when
mowing!
SILVERCUT