Replacing The Protective Curtain - SIP SILVERCUT DISC 340 F FC Betriebsanleitung

SILVERCUT DISC 340 F FC
SILVERCUT DISC 300 F FC, 300 F RC
SILVERCUT DISC 300 F
SILVERCUT DISC 340 F
– Place the mower into work position.
– Release the lever (2) for opening the front flexible
protection (3) and lift it up in order to reach the
discs.
– Replace or turn the blade with the purpose key (4)
as shown in the figure. Pay attention to the left,
right direction of the blade mark (5) and the
direction of the disc rotation when mowing.
– Deposit the new blades seperately left right into
the box with cover (6). Hold the cover open with
one hand!
– The correct blade position is the blade
with direction in the disc turning
direction.
– When one cutting edge is worn out turn
the blade and use the other cutting
edge.
– Inserted blade must be fixed in
movably.

7.4 Replacing the protective curtain

Check regularly the damage of the protective
curtain.Possible raggedness and worn out can not
stop throw outs of hard pieces out of the mower. Such
curtains must be replaced with new ones.
Do not clean the tarpaulin with abrasive cleaners.
– Repair works, maintenance, periodical
overhauls, cleaning and elimination of
funtctional disturbances must be
performed with the switched off drive
and stand still engine! Remove the
ignition key!
43
SILVERCUT