Adjusting The Tension Of The Cylinder-Kneading Machine - SIP SILVERCUT DISC 340 F FC Betriebsanleitung

Instruction for work
– Adjust the tines-kneading machine
intensity according to fodder quantity:
– Much fodder = more opened flap (B).
– Average fodder = flap in middle position.
– A little fodder = more closed flap (A).
– In case of stoppings open the flap more.
3.6 Adjusting the tension of the cylinder-kneading
machine
The cylinder-kneading machine has a distance
between the cylinders from 3 to 5 mm, set by the
manufacturer, and two springs for adjusting the
tension of the kneading. Tension of the kneading can
be adjusted with nuts (1).
1
1
4. Preparing the mower for work and transport
position
– When preparing the machine for
transport and work position always
switch off the P.T.O.shaft. Switch off the
engine and pull out the ignition key.
Secure tractor against movements.
– When driving on public roads use the
protections according to regulations.
38
1A
1B
2