SIP SILVERCUT DISC 340 F FC Betriebsanleitung Seite 147

Instruction for work
Type
Working width
Weight
Transport width
Cardan shaft rotation
(max.)
Disc rotation
Safety clutch (Nm)
Number of discs
Number of blades
Tractor power (min.)
Working speed
Mowing capacity
Conditioner type
Swath width
Connector type
Required hydraulic connections on the tractor
–
2 x floating connectors
–
1 x single–ring connector
Required pressure for machine operation:
–
Minimum required hydr. pressure of tractor is 100
bar.
–
Maximum permitted hydr. pressure of tractor is
150 bar.
Noise level over 70 dB
SILVERCUT
DISC 300 F RC
2895 mm
940 kg
2900 mm
1000 rpm
3000 rpm
1000 / 1200
7
14
60 kW
up to 18 km/h
3,5 ha/h
cylinder
Minimum of 1,400 mm
PH 2
1.4 Road transport (transport width)
– Transport width SILVERCUT DISC 340 F FC =
3283 mm, SILVERCUT DISC 340 F = 3350 mm.
– Check the rules of the road in respective countries.
– The max. transport width in Slovenia is 3050mm,
therefore road transport is NOT ALLOWED
(transport is only allowed with an escorting
convoy).
1.5 Calculation of tractor ballast
Enclosure B standard SIST EN ISO 4254 –10
Due to the weight of the machine, the combination of
tractor and machine could become unstable.
Attaching the machine from the front or the rear or
both must not exceed the permitted total maximum
weight of the tractor, the permitted axle load and tyre
load.
The front axle load must amount to at least 20% of the
unloaded weight of the tractor.
The rear axle load must amount to at least 45% of the
unloaded weight of the tractor.
To calculate the total tractor stability, use the
following formulas.
18