SIP SILVERCUT DISC 340 F FC Betriebsanleitung Seite 161

Instruction for work
Connect both hydraulic couplings next. Lift the hitch
with the tractor by 10cm, so that it no longer sits on the
disconnection support and so that the support leg is in
the air.
3 2
Remove the pin (1), move the support (2) all the way to
the right and place the pin in the right opening. Move
the handle (3) so that the support leg is as parallel as
possible to the upper plain of the frame (bottom
opening of the handle).
Rotate the support leg (1), pull it out and insert it in the
opening, as shown by the arrow.
2
1
1
1
Push the support leg (1) all the way into the transverse
tube, which has a spring at the end. Rotate the pin (2)
to release the elastic pin so it is not fully fitted
anymore and let the spring push it into the transverse
tube. The support leg is now secured against falling
out.
Connect the PTO shaft and secure the guards with
chains, so they do not rotate. If this is our first mower
connection, shorten the PTO shaft to the appropriate
length. The PTO shaft usage is described in the "PTO
SHAFT" chapter in detail.
When the mower is completely lifted, the PTO shaft
should have at least 5cm of free travel until complete
contraction. This distance should however not exceed
15cm, because in that case the protection of the PTO
shaft is too small, when the mower is in the lowest
position.
Install chains to set the working position of the mower
connection.
The recommended working height of the connection is
770mm, as shown in the figure. In this position, the
mower follows the terrain 200 mm downward and
300mm upward. The bearing frame of the connection
should be parallel to the ground for the basic setting of
the mowing height.
32