Mounting The Cardan Shaft; Transverse Adjustment Of The Cutter Bar In Transport Position - SIP SILVERCUT DISC 340 F FC Betriebsanleitung

Instruction for work
–
Danger of material damage: Do not
lower the mower with the hydraulic
before the P.T.O. shaft length is
adjusted.
–
After adjusting and mounting the P.T.O.
shaft perform a test with stand still
P.T.O. shaft, lift the mower from the
lowest to the highest position of the
cutter bar.

2.3.3 Mounting the cardan shaft

4
– Secure the protective tubes (3) with the chain (4)
against rotation on the side of the tractor and the
side of the machine.
– Check the turn and space area of the P.T.O. shaft.
P.T.O. shaft touching the tractor or the machine
may cause damage (touch with 3 point hydraulic
hitch bar, machine connection).
– The PTO shaft must not be removed by fixing it to
the chain.
– Attention! Remove the P.T.O. shaft holder (5),
used for deposing the P.T.O. shaft when
disconnecting the mower.
3
5
3
3
2.3.4 Transverse adjustment of the cutter bar in
transport position
The cutter bar moves transversely by ±5º.
The springs secure the parallel position of the cutter
bar to the tractor, they are placed on each side of the
bar, between the cutter bar and the hitch.
24
4