Tension Of The Driving Belt Of The Kneating Machine's Rotor - SIP SILVERCUT DISC 340 F FC Betriebsanleitung

7.7 Tension of the driving belt of the kneating
machine's rotor
After service-dismantling and renewed mounting of
the kneading machine rotor,check up the belt tension:
SILVERCUT DISC 300 F FC, 340 F FC
New belt from 75 to 79 Hz
(Belt is lowered to 10 mm at a force of 68 N).
Used belt 66 Hz
(Belt is lowered to 10 mm at a force of 52 N).
SILVERCUT DISC 300 F RC
New belt from 65 to 68 Hz
(Belt is lowered to 11,6 mm at a force of 69 N).
Used belt 57 Hz
(Belt is lowered to 11,6 mm at a force of 53 N).
7.8 Lubrication
All lubricating areas are labelled on the image. To
ensure a long life of the mower, consider the
lubricating intervals.
– Repair works, maintenance, periodical
overhauls, cleaning and elimination of
funtctional disturbances must be
performed with the switched off drive
and stand still engine! Remove the
ignition key!
49
SILVERCUT