Checking Alignment And Tooth Backlash Of Drive; Putting The Rc System Into Operation - Reely ROAD COUGAR 4.1 Bedienungsanleitung

4 P
REPARATION
4.4
C
HECK ALIGNMENT AND TOOTH BACKLASH OF DRIVE
The engine transmits its capacity via the pinions on the clutch bell to the main pinion at the center differential.
Both rotary axes, i.e. the crank shaft, engine-sided, and the axis of the drive section to the front and rear axis, must be aligned so that they are exactly
in parallel. This prevents tensions in the drive section, premature wear of the pinions and bearing journals as well as loss of power.
The parallel alignment of crankshaft and drive section must be checked every time before using the vehicle and, if necessary, must
be readjusted!
When the alignment is in parallel, the pinion on the clutch bell and the main pinion will run smoothly.
If there is too much play, this will destroy the toothed wheels in the long run; too little play destroys the bearing in clutch and engine.
Checking the tooth backlash
- Place thin strips of paper between the pinions on the clutch bell and the
main pinions in the drive section.
- Move toothed wheels by hand;
the paper strips must not rip apart when the wheels turn!
Readjusting
- Unscrew four screws of the engine mount fastener on the lower side of
the the mounting plate (chassis)
- Align engine laterally and fasten screws again tightly
- Unscrew four screws, at the top, on the engine support and adjust the
engine vertically
4.5
S
TARTING THE
Take note of the separate operating manual of the Remote control!
- Remove lid of battery compartment on the
lower side of the transmitter.
- Insert 8 AA (rechargeable) batteries in the
compartment,
observe the correct polarity!
- Close the lid again
© REELY 01/08
RC I
NSTALLATION
- Open battery box on the chassis
and
- remove the battery support of the battery
box.
- Place 4 AA batteries (rechargeable
batteries) in the support.
- Observe correct polarity and tightness.
45