C) Putting On Car Body; D) Steering Of Vehicle - Reely ROAD Sports Car Bedienungsanleitung

c) Putting on car body

Guide the antenna tube from the bottom of the car body
through the therefore intended opening.
Now put the car body on the holders and fasten the vehicle
lining with the two holding brackets.
Now your vehicle is ready for the first test drive.

d) Steering of vehicle

Only operate the lever for the drive function very carefully and don't drive too quickly in the beginning
until you are familiar with the responses of the vehicle to the controls.
Do not make any fast or jerky movements on the operating elements of the remote control.
If the vehicle displays a tendency to pull towards the left or right, set the trim for steering on the transmitter accordingly.
After finishing the first test drive the grub screw of the mounting brace on the servo saver (see illustration 6, pos. 2) is
loosened and the steering rods are readjusted in a way that the model drives straight and the steering trim on the
transmitter is in centre position again.
If the steering behaviour of your vehicle does not match your expectations, you can increase or reduce turning move-
ment by changing the steering point on the steering servo.
38
Figure 13