Rip fence placement
The rip fence can be used on either side of the blade. Loosen the wing nuts and remove
the rip fence from the rail. Remove the screws from the rail and insert them from
the other side. Position the rip fence in the desired position and tighten the wing nuts.
The low side toward the blade
Mitre guide
1. Slide the mitre guide into one of the slots on
the table.
2. Undo the locking knob (c) and set the desired
angle. Tighten the locking knob again.
3. If necessary, undo the two wing nuts (d) and
move the rip fence to the side so that it does
not catch on the blade, then tighten the wing
nuts again.
The high side toward the blade
d
16
c