Changing The Blade; Adjusting The Riving Knife - Cocraft HT 10 Bedienungsanleitung

3. Fit the outer flange washer and screw in the lock nut. Hold the drive shaft with
one of the spanners on the outer flange washer whilst simultaneously tightening
the lock nut (clockwise).

Changing the blade

Warning: Make sure that the saw is disconnected from the power supply before
starting to change the saw blade. Wear safety gloves.
1. Remove the saw table insert by
undoing the screw (see picture) and
lifting out the table insert.
2. Set the saw blade to its maximum
height setting by turning the hand
wheel (13) clockwise.
3. Remove the old saw blade using
the two spanners. Then following
the saw blade installation instructions
above, making sure to adjust the riving
knife if necessary (instructions below).

Adjusting the riving knife

Undo the set screw and adjust
the knife so that it follows the curvature
of the saw blade with a maximum
distance from the blade of 5 mm.
13
max. 5 mm