Cocraft HT 10 Bedienungsanleitung Seite 5

20. Check the power tool for potential damage.
- Before using the power tool, make sure that it is functioning normally as
described in this instruction manual.
- Make sure that all the moving parts are intact, properly fitted and rotate freely.
- Damaged safety devices must be replaced by authorised service personnel
unless otherwise specified in this instruction manual.
- Damaged switches must be replaced by a qualified electrician.
- Never use a power tool which cannot be switched on or off using
the designated power switch.
21. Warning:
- Do not use any other accessories than those mentioned in this instruction
manual. Doing so entails a risk of personal injury.
22. Have the power tool repaired by a qualified electrician.
- This power tool conforms to relevant safety regulations. Repairs must only be
carried out by qualified service technicians and only using identical replacement
parts. Failure to do so could lead to serious personal injury.
Specific Safety Instructions for Table Mounted
Circular Saws and Compound Mitre Saws
Warning: Disconnect the mains power plug before any adjustment, service or blade
replacement.
Note: Check that the saw and all safety devices are intact and functioning properly
before switching the saw on.
1. Warning: Use only cross-cut saw blades. Make sure that TCT blades have
negative rake. Do not use blades with deep spacing between the teeth because
the teeth might bend and come into contact with the blade guard. A damaged
blade should be replaced immediately.
2. Do not use the saw unless it has been completely assembled using the instructions
in this manual. Check that the motor and the blade are rotating the right way (see
direction arrow on the blade guard/saw). Make sure that the blade does not come
into contact with the table in any of the settings. Unplug the saw and manually tilt
the blade to 45° and 90°. Adjust the saw head if necessary.
3. If you do not understand how the saw should be used, ask a knowledgeable
person for advice.
4. Never saw freehand. Make sure that the workpiece is firmly secured against
the fence before you start sawing. If the workpiece that you are sawing requires
you to have one hand as close as 10 cm from the blade, secure the workpiece to
the table using a clamp before sawing.
5. Warning: Keep hands at a safe distance from the saw blade. Never saw small
objects. Use a push-stick.
6. Always keep the push stick together with the saw when it is not in use.
5