Cocraft HT 10 Bedienungsanleitung Seite 6

7. Check that the saw blade is well-centred, sharp and that it rotates freely and
without vibration.
8. Let the motor come up to speed before starting to cut.
9. Keep the motor ventilation openings clean and free of dust and debris.
10. Make sure that all clamps are tight before starting to saw, even if the table is
locked at a fixed angle.
11. Make sure that the saw blade and flanges are clean and that the spindle nut is
tight. Use only the blade flanges belonging to your saw.
12. The riving knife should have a radius compatible with the diameter of the saw blade.
13. Use only saw blades having a diameter and speed rating complying with those in
the technical specifications.
14. When sawing long objects, make sure that the ends are adequately supported.
15. Always check the saw blade for cracks and fractures before using it. Replace
a damaged blade immediately.
16. Do not use the saw if any of the parts is missing or if it is in any way damaged or
malfunctioning. Unplug the saw from the wall socket if it makes any unusual noises
or vibrates excessively. Have the saw repaired by qualified service personnel before
using it again.
17. Never use the saw if any of the safety devices is missing or not working properly.
18. Never stretch round or over the saw blade when it is rotating. Maintain a steady
stance and remain balanced at all times.
19. Make sure that the saw blade can rotate freely (especially after transportation/
blade changes) before plugging in and starting the saw.
20. Do not use high speed steel (HSS) blades if the saw is supplied with a tungsten
carbide tipped (TCT) blade.
21. Turn the saw off and wait until the saw blade has completely stopped before
moving the workpiece or adjusting any setting.
22. Do not remove any offcuts or jammed material from around the blade area until
the blade has stopped completely.
23. Never saw into ferrous metals, brick or mortar.
24. Never use the saw near flammable fluids or gas.
25. Make sure that everyone using the saw has read this entire instruction manual.
26. Operators of the saw must be at least 18 years old. Operators aged 16 must be
supervised by an instructor at all times. Keep children away from the saw when it
is connected to the power supply.
27. Makes sure that offcuts of the workpiece are removed from the table to ensure that
they are not ejected by the saw blade.
28. Do not distract the operator/s of the saw.
29. Never try to stop the saw blade by pushing something against the side of
the blade when the power has been turned off.
30. Never use saw blades that do not comply with the specifications in this instruction manual.
6