Responsible Disposal - Cocraft HT 10 Bedienungsanleitung

Abnormal noise
and vibration.
The motor stops,
the workpiece gets
burn marks when
rip cutting.

Responsible disposal

This symbol indicates that this product should not be disposed of with
general household waste. This applies throughout the entire EU. In order
to prevent any harm to the environment or health hazards caused by
incorrect waste disposal, the product must be handed in for recycling
so that the material can be disposed of in a responsible manner. When
recycling your product, take it to your local collection facility or contact
the place of purchase. They will ensure that the product is disposed of in
an environmentally sound manner.
Specifications
Rated voltage
Power
No-load speed
Saw blade
Riving knife
Table size
Saw blade tilt
Dust extraction port
Cutting capacity
LpA (sound pressure level)
LwA (sound power level)
Vibration
Weight
• Check that all parts are correctly assembled and that all
screws and nuts are tight.
• Check that the blade is in good condition and is correctly fitted.
• Check that the floor is level and that the saw has all four
legs squarely on the floor.
• The saw blade may be blunt, replace if necessary.
Refer to the Riving knife and saw blade section above.
• Do not feed the workpiece into the blade too quickly,
slow the feed rate.
• Adjust the riving knife, refer to the Riving knife and
saw blade section above.
220–240 V AC, 50 Hz
S1 1800 W, S6 25% 2000 W
5000 rpm
Ø 250 mm × Ø 30 mm × 2.8 mm, 24 teeth
2 mm
930 × 640 mm
0–45°
Ø 35 mm
85 mm at 90°, 65 mm at 45°
91.0 dB(A)
104.0 dB(A)
< 1.16 m/s²
20 kg
19