Cocraft HT 10 Bedienungsanleitung Seite 7

31. Check before every use that the safety guards covering the saw blade are intact
and work properly.
32. Set the blade guard so that it lies gently against the workpiece during sawing.
Never lock the blade guard in the open position and never alter or remove any of
the safety devices.
33. Do not use the saw for cutting grooves or for rebating.
34. Do not use the saw for cutting slots (grooves which end inside the workpiece).
35. Never use a damaged or faulty safety device, replace it immediately.
36. Never saw workpieces that are too small to hold safely.
37. Always use a table, roller stand, or similar to support long workpieces.
38. Secure round workpieces to the table using suitable clamps to stop them from rotating.
39. Make sure that there are no pieces of metal such as nails or screws in the workpiece.
40. Always ensure that the workpiece is securely pressed against the rip fence and
surface of the table so that it cannot twist whilst being sawed.
41. Never saw more than one workpiece at a time.
42. Never attempt to remove sawdust or offcuts trapped around the blade whilst
the saw blade is rotating. Always switch off and unplug the saw from the wall
socket before adjusting or servicing it.
43. Turn the saw off and disconnect it from the power supply whenever you leave
the work area.
44. All safety devices must be reattached to the saw immediately after any repairs
or maintenance.
45. Always follow all the safety, operating and maintenance instructions in this
instruction manual. Always follow the dimension information specified in
the technical specifications.
46. It is essential to follow all Health and Safety Executive regulations as well as
general safety regulations.
47. If the saw is used with dust extraction equipment in an enclosed space, ensure
that the room has adequate ventilation to prevent the creation of a vacuum.
48. The saw must only be used with a 230 V plug protected by at least a 10 A fuse.
49. Do not use saw blades that are thicker or thinner than the riving knife (applies to
circular saws).
50. Always use a riving knife when rip cutting.
51. Make sure that the riving knife is adjusted so that the distance between the teeth
of the blade and the riving knife is no more than 5 mm.
52. Never carry the saw by its safety devices when moving or transporting it.
53. When the saw is being transported the upper part of the saw blade must be
covered, e.g. by the upper blade guard.
7