Rip Fence - Cocraft HT 10 Bedienungsanleitung

Motor overload cut-out
If the motor is overloaded due to incorrect workpiece feed or the saw blade being
obstructed by debris, the overload cut-out may be triggered.
If the overload safety cut-off switch is triggered:
1. Unplug the mains lead and let the saw cool down for at
least 10 minutes.
2. Make sure that no contaminants hinder the rotation of
the saw blade, brush off and vacuum saw dust as and
when required.
3. Press the overload cut-out reset button (a) pictured.
4. Switch the saw on by pressing [ I ].
Setting the saw blade height
Turn the hand wheel (13) to set the desired height. Never set the blade higher than is
necessary to saw through the workpiece.

Rip fence

Place the rip fence onto the guide rail (15)
and lock it in place by lowering the locking
lever ((b) in the picture).
The rip fence can be attached in two ways,
with the high side or the low side facing the saw
blade (the low side makes it easier to handle thin
material such as plywood). Loosen the wing nuts
and remove the rip fence from the rail.
Position the rip fence in the desired position and
tighten the wing nuts.
15
a
15
b