Cocraft HT 10 Bedienungsanleitung Seite 10

Assembly
Note:
•
Make sure that the saw is disconnected
from the power supply before
commencing assembly.
• Remove all packaging materials and
transport bracing before commencing
assembly.
• Fit all screws and nuts but do not
tighten them during the assembly
process. Wait until all the parts have
been assembled before tightening all
the screws and nuts.
• Use the supplied spanners,
the spanners and the saw blade are
attached to the right-hand side of
the saw when viewed from the front.
• Wear safety gloves when handling
the saw blade, it is very sharp.
Table extension
1. Make sure that the saw blade is at its
lowest setting. Turn the saw upside
down and place it on the floor with
the table facing down.
2. Line the table extension (8) up with
the edge of the saw table (1).
3. Loosely fasten the extension to the table
using hexagon head screws (20), spring
washers (21 a), flat washers (21 b) and
nuts (21). Repeat the procedure on
the opposite side of the table.
4. Screw the support struts (23) to the table
extensions with washers and nuts.
5. Tighten the nuts when both extensions
have been attached.
8
10
1