Riving Knife - Cocraft HT 10 Bedienungsanleitung

Legs
17
23
1. Attach the legs (17) as shown in
the picture. The ends of the support
struts are fastened using the same
screws as the legs, as shown in
the picture.
18 17
3. Screw on the cross braces (18 and 19).
The long cross braces should be
installed parallel to the control/front
side of the saw.
Riving knife and saw blade

Riving knife

1. Remove the saw table insert by
undoing the screw (see picture) and
lifting out the insert.
2. Set the saw blade to its maximum
height setting by turning the hand
wheel (13) clockwise.
2. Push the rubber feet (17a) onto
19
4. Screw on the leg support stays (17b)
11
17a
17
the ends of the legs.
17b
as shown in the picture. They should
be installed on the rear legs.
17