Troubleshooting guide
Problem
Possible cause
The power tool
•
does not work.
•
•
The motor
•
runs slowly.
•
•
Strange noises.
•
•
Heavy
•
vibrations.
Sparks in
•
the motor.
•
Responsible disposal
This symbol indicates that this product should not be disposed of with
general household waste. This applies throughout the entire EU. In order
to prevent any harm to the environment or health hazards caused by
incorrect waste disposal, the product must be handed in for recycling
so that the material can be disposed of in a responsible manner. When
recycling your product, take it to your local collection facility or contact
the place of purchase. They will ensure that the product is disposed of in
an environmentally sound manner.
Specifications
Supply voltage
Input power
No-load speed
Chuck capacity
Sound pressure level
Sound power level
Vibration level
No power.
Short circuit.
Faulty power switch.
Worn/damaged
accessory.
Speed too low.
The motor is overheated.
Mechanical fault.
Faulty windings.
Loose accessory.
Winding short circuited.
Dirty commutator.
220−240 V AC, 50 Hz
150 W
11 000–35 000 rpm
1.6, 2.4 and 3.2 mm
LpA: 73 dB(A), uncertainty KpA: 3 dB(A)
LwA: 84 dB(A), uncertainty KwA: 3 dB(A)
5.08 m/s², uncertainty K: 1.5 m/s²
12
Possible solution
•
Check to see if there is power at
the wall socket.
•
Contact Customer Services if
there is a motor or electrical fault.
•
Sharpen or change the accessory.
•
Alter the variable setting.
•
Apply less pressure to
the workpiece.
•
Contact our Customer Services.
•
Tighten the tool and make sure
it is set correctly.
•
Contact our Customer Services.