Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Blade guard
Screw the blade guard onto the top of the riving
knife. Do not tighten the nut too tightly,
the blade guard must be able to move freely.
Set the blade guard so that it lies gently
against the workpiece during sawing.
Dust extraction port adaptor
If a dust extractor is used, connect
the suction hose (5) between the blade guard
and the dust extraction port adaptor.
Operating instructions
•
Make sure that the saw is completely intact and correctly assembled before
commencing work.
•
Check that the saw blade is vertical (90°) and is not set higher than is necessary
to just manage to saw through the thickness of the workpiece.
•
Regularly check that all nuts and screws are tight.
On/off switch (start/stop)
Plug the mains lead into a wall socket.
Switching on: Push the green button [ I ] to start the motor.
Switching off: Push the red button [ 0 ] to turn the motor off.
No-volt release switch
The saw is equipped with a no-volt release switch which prevents it from starting
automatically when the power comes back on following a power cut. Once power has
been restored the saw must be switched on again by pressing [ l ].
14
Werbung
Inhaltsverzeichnis
