Reely SKY Tutor II Bedienungsanleitung Seite 31

18 Nose landing gear with pedestal, steering lever and attachment
screws
19 Main landing gear wires with set collars
20 Attachment loops for the main landing gear wires
21 Wheels
22 Steerage rods for the nose landing gear, stud bolts
The following components which are not included in the contents of the plane model are required for the assembly and operation:
• Assembly:
Soldering gun, balsa knife, scissors, mini-drill with different bits, miniature cut-off saw, screwdriver, Allen key, foil pin, 5-min epoxy resin, possibly thixotropic
agents (micro-balloon or cotton flock) for thickening the resin, super glue, PVAC glue, sandpaper, iron, foam, rubber rings and Velcro fastener.
Attention!
Observe the security notes of the respective manufacturer when using glues and perform gluing work in well aired rooms only.
When gluing balsa wood with super glue, acidic fumes occur which can be highly hazardous.
• Operation:
You also require a suitable remote control with at least 4 channels, an approx. 10 cm long servo extension cable and a suitable flight battery with the
corresponding plug connectors.
Figure 4
31