Inserting The Batteries; Switching On The Transmitter - Reely SKY 23 96 67 Bedienungsanleitung

a) Inserting the Batteries
The power supply of the transmitter requires 4 mignon batteries (e.g. Conrad order no.: 652504, set of 4, order 1x).
Important!
Use batteries only (1.5 V/cell) instead of rechargeable batteries (1.2 V/cell) for transmitter power supply.
Proceed as follows to insert the batteries:
The battery compartment lid (1) is located on the back of
the transmitter. Press the corrugated triangle (2) and push
off the lid downwards.
Now put four batteries in the battery compartment. Always
make sure the polarity of the batteries is correct. The polarity
is indicated (3) at the bottom of the battery compartment.
Then slide the cover of the battery compartment back on
and let it snap into place.
b) Switching on the Transmitter
Slide the function switch (also see figure 1, item 6) from the
position „OFF" to the position „ON".
The display shows the current battery voltage (1), the
currently set remote control mode 1 or 2 (2), the current
lever sensitivity „N" (3) and the position of the digital trimming
for the four control directions (4).
Attention!
if the power supply is no longer sufficient for pro-
per operation of the transmitter, the display
„LOW" (5) appears in the display.
In this case, terminate flight operation of the
model immediately And insert a new set of
batteries in the transmitter.
Figure 2
Figure 3
37