F) Practical Flight Advice For The First Start; Trimming The Helicopter - Reely SKY 23 96 67 Bedienungsanleitung

f) Practical Flight Advice for the First Start

• Even if the model can fly in the narrowest spaces, for the first test flights, we recommend using a free space of about
3 x 3 m.
• The support should be flat (tiles, parquet flooring, or similar) to allow you to determine even before take-off if the
model tends to drift off in a particular direction.
• Place yourself exactly behind your helicopter. As long as you can see your model from behind, it will react to the
control commands: right, left, forward, backward exactly as you see it. Whereas, if the cockpit of the model points
towards you, it reacts exactly the opposite way from your steering commands at the transmitter.
Caution, important!
If the rotors hit any objects and are blocked or if the model falls over when standing, slide the pitch lever
into the bottom-most position at once so that the two drive motors are no longer supplied with power.
g) Trimming the Helicopter
First start the model, then the transmitter. The trimming lever for the pitch function must be in the bottom-most position
for this (motor off).
Push the pitch lever from the bottom position (engine off) forward very carefully so that the two rotors start up.
Caution, important!
If the rotors do not start up when the pitch lever is slowly moved from the bottom-most position forwards,
the bottom-most position (motor off) was not recognised correctly. In this case, push the pitch lever all the
way up and back to the bottom-most position. If this is not successful, push the lower one of the two trim
buttons for the pitch function so that the marking arrow in the display moves down (see following section).
If the motors start up, observe your model's behaviour. Shortly before the helicopter starts hovering, you can already
determine in which direction your model wants to move.
47