Fine Tuning Of The Helicopter - Reely SKY 23 96 67 Bedienungsanleitung


11.

Fine Tuning of the Helicopter

If the nod or roll trim must be adjusted a lot fort he helicopter to hover stably, you can also mechanically adjust the
swash plate linkage.
For this, lift the canopy from the two retaining pins on the
left and right (see figure 13).
The swash plate is controlled by two linkage rods (1) at the
front with one ball joint ring (3) each.
These rings can be carefully removed from the joint balls of
the swash plate.
If you turn the joint ring on the linkage rod, the rods can be
extended or shortened, depending on rotational direction.
Then the joint ring is attached to the swash plate ball again
carefully.
The left joint ring (2) of the swash plate in flight direction is
Figure 27
responsible for the roll function.
If the linkage rod is shortened, the helicopter flies to the left. If the linkage rod is extended, the helicopter flies to the
right.
The right joint ring (3) of the swash plate in flight direction is responsible for the nod function. If the linkage rod is
shortened, the helicopter flies forwards. If the linkage rod is extended, the helicopter flies backwards.
Set the linkage rods so that the model helicopter hovers stably without any large adjustments of the nod and roll trim
out of the centre position being required.
52